Other information:
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
When using an impact gun, final tightening torque should be checked using a torque wrench.
Run out inspection
1.
Jack up the ...
Description
Pre-Charge Resistor is installed in the Power Relay Assembly
(PRA) and it protects the high voltage circuit by limiting the charging
current when the inverter capacitor is being pre-charged.
[With High Voltage Battery Heater System]
1. Main Relay (+)2. Main Relay (-)3. Pre Cha ...