Kia Soul EV: Heater / Heater Unit Components and Components Location

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Heater Unit Components and Components Location

Component Location

1. Heater unit




Components
[LH]

1. Floor shower duct assembly [LH]
2. Duct sensor
3. Interior condenser cover
4. Heater core cover
5. Temp door arm
6. Temp door lever
7. Temp actuator motor assembly
8. Floor door lever
9. Mode actuator motor assembly [LH]
10. Mode cam
11. Motor & wheel assembly



12. Ventilation guide
13. Heater case [LH]
14. Duct sensor
15. Joint flange cap
16. Interior condenser
17. Evaporator core lower insulation
18. Floor door assembly
19. Vent door assembly [LH]
20. Cowl top cover - Heat seal
21. Cowl top cover - Heat seal
22. Cowl top cover - Heat seal




[RH]

1. Evaporator core
2. Joint flange cap
3. Heater lower door
4. Temperature control door
5. Floor door assembly [RH]
6. Vent door assembly [RH]
7. Defogging door assembly [LH]
8. Ventilation guide
9. Heater case [RH]



10. Defogging actuator motor assembly
11. Vent door arm
12. Mode cam
13. Mode actuator motor assembly [RH]
14. PWM blower motor
15. Floor door lever
16. Floor door arm
17. Floor shower duct assembly [RH]
18. Drain hose




Heater
...

Heater Unit Repair procedures
Replacement     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Fai ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Brake Bleeding Prcoedure


AHB Brake System Bleeding procedure     • Do not reuse the drained fluid.. • Always use genuine DOT3/DOT4 brake fluid. Using a non-genuine DOT3/DOT4 brake fluid can cause corrosion and decrease the life of the system. • Make sure no di ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Auto Light Sensor Repair procedures


Inspection In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor''s input. During IGN1 ON, the BCM monitors the range of this supply and alerts the f ...

Copyright © www.ksoulev.com 2020-2025