Other information:
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminals No. 1 and No. 2.
2.
Inspect the voltage value whether it is within the specified range.
Voltage = 0.00878835 * Pressure + 0.5[PSIA]
3.
If the measured voltage value is not within t ...
Circuit Diagram
Connector Pin Information
No.Wire harness connectorPanorama motorBlind motor1Ground 1Ground 1Ground 22Glass status signal / Tool glassGlass status signal/ Tool (Parameter)Tool (Parameter)3IGN 2IGN 2-4Up switchUp switch-5---6Battery 1Battery 1Battery 27Ground 2SerialSerial8Vehic ...