Kia Soul EV: Front Seat / Front Seat Frame Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Frame Assembly Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat back cover.
(Refer to Front Seat - "Front Seat Back Cover")
2.
Remove the front seat cushion cover.
(Refer to Front Seat - "Front Seat Cushion Cover")
3.
Disconnect the connector (A).
4.
After loosening the mounting bolts, separate the front seat back frame assembly (B) and front seat cushion frame assembly (C).

Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

5.
Install in the reverse order of removal.
   
Remove the side air bag to replace the side air bag installation seat.
(Refer to Restraint - "Side Airbag (SAB) Module")
Before servicing, be fully aware of precautions and service procedures relevant to air bag.
(Refer to Restraint - "Side Airbag (SAB) Module")
Front Seat Frame Assembly Components and Components Location
Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

Front Seat Belt
...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: SRS Control Module (SRSCM) Repair procedures


Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning to work. 3. Disconnect the DAB, PAB, SAB, CAB and BPT connectors. 4. Remove the floor console. (Refer to Body - "Floor console") 5. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Front Impact Sensor (FIS) Description and Operation


Description The Front Impact Sensors (FIS) are installed in the Front End Module (FEM). These remote sensors are used to detect acceleration due to a collision at the mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Fr ...

Copyright © www.ksoulev.com 2020-2024