Kia Soul EV: Front Seat / Front Seat Cushion Cover Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat shield inner cover. (Refer to Front Seat - "Front Seat Shield Inner Cover")

2.	Remove the front seat shield outer cover. (Refer to Front Seat - "Front Seat Shield Outer Cover")

3.	Remove the front seat lower protector (A).

4.	Disconnect the connectors (A).

5.	Detach the air ventilation seat cushion duct (B) by pulling the lock pin (A).

6.	Pull out the hooks (A) and front seat cushion cover (C) from the front seat cushion frame (B).

7.	Remove the front seat cushion cover (A) from the front seat cushion frame.

8.	After removing the velcro tape (A) and hog-ring clips (B) from inside the front seat cushion cover, separate the front seat cushion cover (C).

Install in the reverse order of removal.

•	To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Front Seat Cushion Cover Components and Components Location

Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly Components and Components Location

Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: EPB Switch Repair procedures

Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3. Remove the EPB switch assembly. Installation 1. Install the EPB switch assembly to the floor console upper cover. 2. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Schematic Diagrams

Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal Harness Connector Pin No.Function (Connector A)Pin No.Function (Connector B)1--1--2--2--3--3--4- -4--5GA/C Control Module (SBR PASS)5BPassenger Side ImpactSensor (High)6--6YPassenger Side ImpactSensor ...