With the fog lamp switch in each position, make sure that
continuity exists between the following terminals. If continuity is not
as specified, replace the multifunction switch.
Removal
Front Fog Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Remove the front fog lamp assembly (A) after loosening the mounting screws.
4.
Remove the front fog lamp bulb (A) by turning in the counter clock-wise direction.
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the lower crash pad switch assembly (A ...
Inspection
Smart Key Unit
–
Refer to Smart key System - "Smart key Diagnostic"
Smart Key Switch
–
Refer to Smart key System - "Smart key Diagnostic"
Antenna
–
Refer to Smart key System - "Smart key Diagnostic"
Trunk Lid Open Switch
1.
Check for continuity ...
High Voltage Shut-off Procedure
Be sure to read and follow the “General Safety Information
and Caution” before doing any work related with the high voltage
system. Failure to follow the safety instructions may result in serious
electrical injuries.
...