Replacement
1.
Remove the cap (A), the nuts and the wiper arm (B).
Tightening torque :
22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)
2.
Remove the glue from both ends (A) of the ho ...
Other information:
Inspection
1. Vcc2. Ground
Check the voltage between terminals 6 and 7.
1.
Using the tester, check the resistance between terminals 1 and 2.
TemperatureResistance°C°FSpecification [K?]Tolerance [%]-40-40225.1± 3.06-30-22129.3± 2.49-20-476.96± 1.95-101447.34± 1.4603230± 1.00 ...
Component Location
1. Blower unit
Components
1. High voltage PTC heater core2. Ionizer3. Evaporator temperature sensor4. Air inlet filter cover assembly5. Heater core pipe mounting bracket6. Heater - evaporator seal7. Intake duct case [LH]8. Intake arm9. Intake actuator motor assembly10. ...