Kia Soul EV: AVN System / AVN Head Unit Components and Components Location

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / AVN System / AVN Head Unit Components and Components Location

Components

AVN (A/V & Navigation) Head Unit Connector

Connector Pin Information

No.	Connector A	Connector B	Connector C
1	Rear left speaker (+)	MM CAN high	C CAN (-)
2	Front left speaker (+)	-	C CAN (+)
3	Front right speaker (+)	Parking	-
4	Rear right speaker (+)	Steering remocon	-
5	-	-	OBC wake up
6	-	MTS key	-
7	ALT L	AUX video	-
8	Illumination (+)	AUX right input	-
9	R position	AUX ground	-
10	Rear left speaker (-)	MIC (+)	-
11	Front left speaker (-)	Battery (+)	B CAN (+)
12	Front right speaker (-)	Battery (+)	B CAN (-)
13	Rear right speaker (-)	MM CAN low	-
14	Ignition 3	Auto light	Airbag
15	-	P position	-
16	Door unlock	Speed	-
17	Illumination (-)	Remocon ground	-
18	Remote antenna	ACC	Door open
19	?	AUX video ground	-
20		AUX DETECT	-
21		AUX left input	Ground
22		MIC (-)	Video ground
23		Ground	Camera video input
24		Ground	Camera battery (+)

Description and Operation

Description Limitations of the Navigation System GPS Signal Reception State As the GPS satellite frequency is received/transmitted in straight lines, reception may not work if hiding devices ar ...

AVN Head Unit Repair procedures

Removal Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and ap ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: A/C Pressure Transducer Repair procedures

Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminals No. 1 and No. 2. 2. Inspect the voltage value whether it is within the specified range. Voltage = 0.00878835 * Pressure + 0.5[PSIA] 3. If the measured voltage value is not within t ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: EPB Switch Repair procedures

Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3. Remove the EPB switch assembly. Installation 1. Install the EPB switch assembly to the floor console upper cover. 2. ...