Kia Soul EV: Air Conditioning System / Ambient Temperature Sensor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Ambient Temperature Sensor Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect ambient temperature sensor.
3.
Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it is changed by changing of the ambient temperature.

1. Sensor Ground
2. Ambient Sensor Signal

Specification
Ambient temperature
[°C(°F)]
Resistance between terminals 1and 2 (k?)
-10(14)
158.18
0 (32)
95.10
10 (50)
58.80
20 (68)
37.32

4.
If the measured resistance is not within the specification, substitute with a known-good ambient temperature sensor and check for proper operation.
5.
If the problem is corrected, replace the ambient temperature sensor.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the engine room under cover.
(Refer to Traction Motor Systerm - "Under Cover")
3.
Disconnect the connector and then remove the ambient temperature sensor (A).

4.
Install in the reverse order of removal.
Ambient Temperature Sensor Description and Operation
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower te ...

Cluster ionizer Description and Operation
Description The cluster ionizer makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When the air-conditioner or ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: High Voltage Battery Heater Fuse Repair procedures


Removal     Main Relay, Pre Charge Relay, Pre Charge Resistor, Battery Current Sensor, High Voltage Battery Heater Relay and the High Voltage Battery Heater Fuse are integrated in the Power Relay Assembly (PRA). So Refer to the removal procedure of Power Relay Assem ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Pack Assembly Repair procedures


Inspection     When removing the battery pack assembly to inspect the battery system, it can be connected to vehicle by using the SST 0K918-E4100, 0K375-E4100, 0K375-E4200. Before installing the battery system assembly, check if the battery is OK by using the SST. ...

Copyright © www.ksoulev.com 2020-2025