Kia Soul EV: Rear Seat / Rear Seat Assembly Repair procedures
[Rear seat back assembly]
1.
Detach the rear seat belt lower anchor (C) by pushing the lock pin (B) of center mini buckle (A) with flat-tip driver.
2.
Fold the rear seat back assembly.
3.
Remove the center hinge cover (A).
4.
Loosen the rear seat back mounting bolt (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)
5.
Remove the rear seat back assembly (A).
6.
Install in the reverse order of removal.
[Rear seat cushion assembly]
1.
Remove the trunk trim.
(1)
Remove the luggage cover board (A).
(2)
Remove the luggage box (A).
2.
Remove the rear seat back[LH].
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Loosen the rear seat cushion mounting bolt (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)
4.
Remove the rear seat cushion assembly (A) by pushing it up.
5.
Disconnect the heater cushion connector (A).
[LH]
[RH]
6.
Install in the reverse order of removal.
Component Location
1. Rear seat back assembly [LH]2. Rear seat back assembly [RH]3. Rear seat cushion assembly
...
Component Location
1. Rear seat back cover [LH]2. Rear seat back cover [RH]
...
Other information:
Component Location
1. Front door window glass
...
Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable.
3.
Check for continuity between the outer poles of antenna cable. There should be continuity.
4.
If there is no continuity, replace ...